Table of Contents
Advertisement
◉ ◉ CLEAN OF BATTERY TERMINAL
Clean the battery terminal when it is
dusty or rusted.
1. Set the ignition switch "OFF" position.
2. Disassemble the seat, disassemble the
(
+
) positive battery wire after the (
negative battery wire.
Remove the battery.
3. Clean the terminal.
If there is white dust, clean it with warm
water.
4. Assemble the battery wires and grease
the terminal lightly.
CAUTION
● Keep the battery away from fires.
● When disassemble the battery wire,
take off �
terminal first with the igni-
tion switch "OFF" position. When
assemble, �
● Fasten certainly the battery wires.
● Incorrect installation of the battery
will reverse the terminal position
resulting in possible electrical sys-
tem damage due to incorrect battery
lead connection.
● Never charge a battery while still in
the machine as damage may result
to the battery or regulator / rectifier.
terminal first.
If the air cleaner element has become
clogged with dust, intake resistance will
-
)
increase with a resultant decrease in power
output and an increase in fuel consumption.
If riding under severe conditions must be
cleaned or replaced more frequently than
maintenance schedule. Check and clean
the air cleaner element periodically accord-
ing to the following procedure.
If the air cleaner element is polluted, will
occur to starting go out, output
insuffiency, combustion effciency
decline, and sooty smoke(black smoke).
This appearence is occurred at first to
clean the air cleaner element and con-
firm.
1. The air cleaner is located under the fuel
tank.
Remove the fuel tank.
2. Remove the eight screws
3. Pull up the air cleaner cap
cleaner element
52
AIR CLEANER
CAUTION
①
.
②
③
.
, and the air
Advertisement
Table of Contents
