HP 262586-B21 - IP Console Switch 3x1x16 KVM User Manual page 92

92 HP IP Console Switch User Guide
3. Configure the terminal emulation software for the server, such as
4. Plug the supplied power cord into the power cord connector ("Components"
5. Power on the HP IP Console Switch, if not already powered on. The activity
6. Select Option 1—Network Configuration. The Network Configuration
7. Select Option 1 to set the Network Speed. When possible, set the connection
8. Select Option 2 to specify a Static/BootP IP address. Use a static IP address
Hyperterminal or Minicom ("Configuring Minicom" on page 93).
on page 7) on the HP IP Console Switch and then into a valid power source,
if not already connected.
indicator light ("Components" on page 7) powers on. The activity indicator
blinks for 30 seconds while performing a self-test. Approximately 10
seconds after it stops blinking, press the Enter key to access the Main menu.
menu appears.
manually without relying on the auto negotiate feature. After you enter a
selection, return to the Network Configuration menu.
for ease of configuration. If you are using a BootP address, configure the
BootP server to provide an IP address to the console switch, omit step 9, and
continue to the next procedure.