Operation; Specifications - Craftsman Speedy Lift 950156 Operator's Manual

KNOW YOUR JACK
Compare Fig. 4 illustration
BEFORE operation to become familiar with
the location of various jack components.
Jack Handle
Magnetic Tool Tray
(remove to access Oil Filler Plug)
Oil Filler Plug
(located beneath Tool Tray)
Handle
Socket
Release Valve
(inside Handle
Socket, engage
Rear
with Jack Handle)

SPECIFICATIONS

Rated Capacity: 4 Ton / 8000 Lbs
Jack Dimensions: 27-1/4"
7/16"
Lifting Range: 5-3/4"
(145 - 504 mm)
Oil Capacity: 235 c.c.
Net Weight: 89.1 Lbs (Approx.)

OPERATION

with your jack
addle
Lifting Arm
Front Wheel
Castor
FIG.
x 13-1/4" x 6-
19-13/16" (Approx.)
BEFORE USE
• Read the operator's
and familiarize yourself thoroughly with the
product, its components and recognize the
hazards associated
• Occasionally during shipping and handling,
the hydraulic
unstable or air may trapped in the system,
both of which can interfere with the jacks
lifting performance.
To stabilize
•
recommended to cycle the jack a few times
without applying load:
• Close release valve by turning the jack
handle clockwise until tight.
• Pump the handle until the jack saddle
reaches its maximum height.
Open release
handle
than 1/2
saddle to reach its lowest position.
• Repeat
times.
To release air from the hydraulic system:
•
• Open the release valve by turning the
jack handle counterclockwise,
by more than 1/2 full turn at a time.
4
• Remove
cylinder (Fig. 4).
• Rapidly
several
• Reinstall
cylinder again and jack is now ready to
use.
BEFORE EACH
Make a visual inspection
of the floor jack by checking for abnormal
conditions, such as cracked
damaged, loose, or missing parts.
DAMAGE
If you think jack has been subjected
abnormal load or shock, have it inspected for
damage at a Sears or other qualified service
center before using it again.
4
manual completely
with its use.
oil in jack may become
the hydraulic
valve by turning
counter-clockwise,
full turn at a time.
the above procedure
the oil filler screw
pump jack handle
full strokes.
the oil filler screw
USE
before each use
welds, leaks and
TO JACK
oil, it is
jack
but no more
Allow the
a few
but never
from the
through
into the
to an