Craftsman SPEEDY LIFT 950156 Operator's Manual page 3

• Study, understand,
instructions with
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• This is a lifting device only. Immediately
after lifting, support
appropriately rated vehicle stands.
• Do not move or dolly the vehicle while
on the jack.
• Failure to heed product
warnings may result in personal injury
or property damage.
Leer, comprender, y seguir Ias instrucciones
antes de utilizar eI aparato.
de instrucciones
seguridad deben estar comunicado
lengua del operador
seguir estas indicaciones
danos personales o materiales.
TO ASSEMBLE
HANDLE
• Locate the spring pin on bottom end of upper
handle and the spring pin receiver on the
upper end of lower handle. (Fig. I).
• Align the spring pin with the spring pin
receiver Connect the two handle pieces
together by pressing
insert until the spring pin is locked in the
spring Pin receiver.
TO ASSEMBLE
THE SOCKET
I. Press and hold the handle
the lock pin (Fig. 2).
2. Pull out the lock pin, then release handle
socket slowly.
ACaution: Handle socket i sspringloaded.
Beware of pinching
removal of lock pin.
3. Pull and hold the spring knob (Fig. 3).
4. Insert the assembled
socket, until it is firmly seated.
5. Release spring knob to secure the handle
in position.
SAFETY
and follow
and on this device
the vehicle with
markings
EI manual
y la informacion
antes del uso. No
puede causar
ASSEMBLY
THE TWO PIECE
the spring pin and
THE HANDLE INTO
socket to loosen
on fingers during
handle into
INSTRUCTIONS
all
or
! SAFETY
Be sure all tools and personnel
before lowering
shall be made
attachments
the manufacturer
on areas of the vehicle as specified by the
vehicle manufacturer.
de
en
NOTE: Jack stands
unless otherwise
Use 1 matched pair per vehicle only.
Upper Handle
FIG• I
FIG. 2
Assembled
Handle
the
Spring Knob
FIG. 3
3
NIN
To avoid crushing
related injuries:
NEVER work
under or around
supported only by jack.
ALWAYS use adequately
rated jack stands.
MESSAGE
load. No alterations
to this product.
and/or adapters supplied by
shall be used. Lift only
are rated per pair
noted.
Spring Pin
Spring Pin Receiver
Lower Handle
Handle Socket
Lock Pin (to hold the
position of Handle
Socket in packaging)
Handle Socket
and
on,
a load
!
are clear
Only