JVC KD-AVX44 - DVD Player With LCD monitor Instructions Manual page 554

When using the optional stay
Dashboard
Removing the unit
Before removing the unit, release the rear section.
A
Connecting the parking brake lead
Connect the parking brake lead to the parking brake system built in the car.
Parking brake
B
Connecting the reverse gear signal lead (for rear view camera) (REVERSE GEAR SIGNAL)
Locate the reverse lamp lead in the trunk.
Reverse lamp lead
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
Stay (option)
Fire wall
Screw (option)
30˚
Install the unit at an angle of less than 30˚.
Parking brake switch (inside the car)
Reverse lamps
When installing the unit without using the sleeve
In a car having the "Required space for installation" (see page 1), first remove the car radio and install the
unit in its place.
2
Flat type screws—M5 x 8 mm *
Bracket * 2
2
Bracket *
Note: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws.
If longer screws are used, they could damage the unit.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
Extension lead (not supplied)
To reverse lamp
Crimp connector
(not supplied)
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
2
* 2
Not included for this unit.
Flat type screws—M5 x 8 mm
Parking brake lead (light green)
To metallic body or chassis of the car
Purple with white stripe
To car battery
Reverse lamp lead
2
*