DAELIM S-FIVE Service Manual page 73

MOVABLE DRIVE FACE INSPECTION
● The weight rollers push on the movable drive pulley
face (by centrifugal force); worn or damaged weight
rollers will interfere with this force.
● Check the rollers for wear or damage and replace as
necessary.
● Measure the O.D. of each roller, replace if the service
limit is exceeded.
SERVICE LIMIT : 15.4mm
● Check the drive face boss for wear or damage and
replace as necessary.
● Measure the O.D of the drive face boss. Replace the
boss if the service limit is exceeded.
● Measure the I.D. of the drive face. Replace it if the
service limit is exceeded.
● Movable drive face boss outer diameter
SERVICE LIMIT : 19.97mm
● Movable drive face inner diameter
SERVICE LIMIT : 20.6mm
MOVABLE DRIVE FACE ASSEMBLY/INSTALLATION
● Install the weight roller on the movable drive face.
● Install the ramp plate.
● Pack the inside of the movable drive face with the
specified amount of grease.
● Install the movable drive face boss.
NOTE
·Do not get the grease on the pulley face. Remove any
misplaced grease with a degreasing agent.
● Install the movable face assembly on the crankshaft.
KICK STARTER/CONTINUOUSLY VARIABLE TRANSMISSION
MOVABLE DRIVE FACE
7-7