DAELIM S-FIVE Service Manual page 4

SERVICE INFORMATION
3. Store the parts of each system discriminatively to install
each part in the right place.
5. Clean the parts after the overhaul and before the test and
remove the cleaning oil with compressed air. Apply oil
to seal face during installation.
7. Align the bolts to uniform the tightening points before
tightening them when you don't know the bolt length.
9. Check to see if the rubber part is worn out when
removing it and replace it if necessary. Some rubber part
is weak to gasoline and kerosene, so pay attention not to
soak with gasoline or oils.
1-2
4. After removing gasket, O-ring, piston pin clip and cotter
pin, always replace them with the new one. When
removing the snap ring, it can be easily missed after
transformation or installation.
6. Check necessary place and measure necessary data
during installation. When installing, return to the state
before removing.
8. Bolts, nuts and pieces must be tightened from the bigger
diameter to the smaller one, from inside to outside and
diagonally with the specified torque.
10. Recommended grease must be applied to or filled in
the specified place.