Rolling Code" Programming - Dodge 2004 Intrepid Owner's Manual

NOTE: Some entry gates and garage door openers may
require you to replace step 4 with the procedures listed
under Canadian Programming.
5. The indicator light in the Universal Transceiver will
begin to flash, first slowly and then rapidly. The rapid
flashing indicates successful programming. If after 90
seconds the indicator light does not flash rapidly or goes
out, return to step 1 and repeat the procedure. To train the
other buttons, repeat steps 3 and 4. Be sure to keep your
hand held transmitters in case you need to retrain the
Universal Transceiver.
If you do not successfully program the Universal Trans-
ceiver to learn the signal of your hand held transmitter,
refer to the Rolling Code Paragraph, or call toll free for
customer assistance at 1–800–355–3515, or on the internet
at www.homelink.com.

"Rolling Code" Programming

NOTE: If your hand held transmitter appears to pro-
gram the Universal Transceiver, but your garage door or
other device does not operate, and your device was
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 73
manufactured after 1996, your garage door opener or
other device may have a "Rolling Code" system.
On garage door openers with the "Rolling Code" feature,
the transmitter code changes after each use to prevent the
copying of your code.
To check if your device is protected by a "Rolling Code"
system:
Check the owner's manual for the device for mention
of "Rolling Codes".
Press and hold the programmed button on the Univer-
sal Transceiver. If the Universal Transceiver indicator
light flashes rapidly and then stays on after 2 seconds,
the device has the "Rolling Code" feature.
To train a garage door opener (or other rolling code
equipped devices) with the rolling code feature, follow
these instructions after completing the Programming
portion of this text:
NOTE: The assistance of a second person may make the
following programming procedure quicker and easier.
3