Motorola LI4278 Manual

PAIRING THE UNIT TO iOS TABLET

FOLLOW THESE 10 EASY STEPS:

1. Set LI4278 Factory Defaults
   
2. The following barcodes must be scanned before attempting to pair the scanner to the Apple device.
   Note: This feature is only available with LI4278 firmware PAABIS00-002-R00 or higher.
   
3. Select Settings from the iPad Desktop:
   
4. Turn Bluetooth On:
   
5. Choose LI4278 from available Bluetooth devices. The serial number of the device assists in identifying the correct device:
   
6. Tap the LI4278 to select it. The iPad automatically connects to the linear imager. The scanner emits a short low beep followed by a short high beep indicating the successful connection.
   
7. The device is now connected to the iPad as a keyboard device. Test it in an application that accepts keyboard input, such as Notes.
   
8. Tap the white + in the upper right to start a new Note.
   
9. Scan a barcode. It is displayed in the Note:
   
10. A quick double-pull of the scanner trigger will open or close the virtual keyboard.
    

Auto-reconnect Immediately

1. Scan Option
   
2. Scan <Data><Suffix>
   
3. Scan Enter