Rear Panel Connectors; Hardware Installation; Dip Switches - D-Link Dgs-1026P Quick Installation Manual

Rear Panel Connectors

1 2
Figure 3
# Item
Kensington
This is used to attach a physical Kensington
1
Lock Input security lock.
Switch GND
2 This is used to connect the switch to ground.
Power Cord
This is used for securing the power cord
3
Retainer Slot retainer to the switch.
Power Adapter
This is used to connect the power cable to the
4
Input
switch.
Table 3

DIP Switches

Figure 4
The DIP switches on the front panel allow easy
configuration of the advanced features of the DGS-
1026P.
DIP Switch Function Controlled
Flow Control Enables/Disable Flow Control Feature
Port Isolation: When enabled, ports 1 to
23 will be isolated from each other, but
will still be able to communicate with port
Port Isolation
24. Port 24 will be able to communicate
and with all the ports available on this
Storm Control switch. Storm Control: When enabled,
a broadcast storm control threshold
value of 128 kbps will be applied to
incoming broadcast packets on all ports.
Equipped with PoE extend technology
250M
to 250m with data transmission.
If the PD-Alive is enabled, the PoE
ports (ports 1-24) can detect whether
PD-Alive (TBA)
the connected PDs are alive and
automatically reboot the connected
PDs once they become unresponsive.
Table 4
3 4
Description
Default
On
Off
On
Off

Hardware Installation

Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures, and personal injury:
• Install the DGS-1026P in a cool and dry place.
Refer to the technical specifications in the
user manual for the acceptable operating
temperature and humidity ranges.
• Install the switch in a site free from strong
electromagnetic sources, vibration, dust, and
direct sunlight.
• Leave at least 10 cm of space at the left and right-
hand side of the switch for ventilation.
• Visually inspect the power connector and make
sure that it is fully secured to the power cord.
• Do not stack any devices on top of the switch.
Using the Switch on a Flat Surface
The DGS-1026P comes with a set of adhesive rubber
feet which allow the switch to be placed on a flat
surface such as a desk or table, without risk of
damaging it. To attach the rubber feet, simply place
one in each corner of the bottom panel of the switch.
Figure 5
3