Change A Programme; At The End Of The Programme; Low Power Mode - Electrolux Ew6Hch28G User Manual

10.3 Change a programme

1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
Alternatively:
1. Rotate the selector knob to the
position.
2. Wait for 1 second. The display shows
.
3. Set the programme.

10.4 At the end of the programme

When the programme is completed:
• An intermittent acoustic signal operates.
• The display shows
• The indicators
comes on.
• The Avvio/Pausa indicator is on.
The appliance continues to operate with the
anti-crease phase for approximately 30
minutes or more if Antipiega option was set
Option - Antipiega ).
(see chapter
The anti-crease phase reduces creasing.
You can remove the laundry before the anti-
crease phase is completed. We recommend,
for better results, that you remove the laundry
when the phase is almost completed or
completed.
When the anti-crease phase is completed:
• The display still shows
• The indicators
comes on.
• Avvio/Pausa indicator goes off.
1. Press the on/off button to deactivate the
appliance.
"Reset"
Filtro and Serbatoio
Filtro and Serbatoio
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
OPTIONS: Dryness Level -
See chapter
Adjustment of the target final moisture
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
Always clean the filter and empty the
water container when a programme is
completed.
Leave the door slightly opened after
every cycle to avoid moisture.

10.5 Low power mode

To reduce energy consumption, this function
automatically deactivates the appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme or anticrease phase.
The time is reduced to 30 seconds if the
selector knob is pointing to
position.
When the appliance goes in low power
mode, the display and icons turn off. You
can reactivate it by pressing on/off
button.
"Reset"
ENGLISH 17