Attach Hose; Attach Handle; Position Tools - Hoover U5194 Owner's Manual

Attach hose

1-8
A
B
Align end of hose with projections
(A) over slots on dirt duct (B).
Slide hose into slots and twist hose
to lock it into place (To detach hose,
reverse procedure).

Attach handle

1-10
A
DO NOT remove orange tie wrap
until step 1-11 is complete.
Grasp orange tie wrap (A) and pull
until the black plug (B) comes out of
the handle cavity.
1-12
D
E
Align the groove (D) on the back of
the upper handle with the small pro-
jection (E) on the back of the handle
housing.
4
Position hose
1-9
Position hose over rack (C) and into
hose tube (D).
NOTE: Hose must be connected at
the hose tube (D) and at the dirt
duct (B) on the back of the cleaner
for carpet or floor cleaning. For
tool use, refer to Fig. 2-11.
1-11
A
B
B
Hold plug (B) with one hand; upper
handle (C) with other hand.
Push plug into upper handle, align-
ing with opposite end of plug and
push firmly UNTIL YOU HEAR A
SNAP OR A CLICK.
After ends are connected, pull on
plug to make sure it is securely
attached.
1-13
Press button (F) at handle base and
push handle all the way down.
C
B
C
PUSH
FIRMLY UNTIL
YOU HEAR A
SNAP OR
CLICK!
F
D
Note: The plug will only fit together
one way. If plug is not fitting togeth-
er, check alignment of ends.
After the plug ends are fully con-
nected, the orange tie wrap (A)
must be removed.
Use caution so as NOT TO CUT
the black power cord. Discard the
orange tie wrap.
1-14
D
C

Position tools

Place smaller diameter end of wand
(A) into bottom of rack. Snap wand
into clip at top. Repeat with other
wand.
Crevice tool (B) fits into one of the
extension wands.
Fit combination tool (C) and pow-
ered hand tool (D) into storage
areas on side of cleaner as shown.
B
A