Connecting The Power Cord; Installing The Cotton Stand - Brother BAS-300G Basic Operation Manual

3-11. Connecting the power cord

<Single-phase
specifications
<Three-phase
specifications

3-12. Installing the cotton stand

>
Green and yellow wire
(ground wire)
>
Green and yellow wire
(ground wire)
BAS-300G, BAS-311G, BAS-326G
1. Attach an appropriate plug to the
power cord (1). (The green and yellow
wire is the ground wire.)
2. Insert the
properly-grounded AC power supply.
* The inside of the control box uses
single-phase power.
NOTE:
Do not use an extension cord. If this is
not observed, it may cause problems
with correct operation.
5239Q
(1) Cotton stand
NOTE:
Fit the washer (2), and then securely
tighten the nut (3) so that the cotton
stand does not move.
2974B
3. INSTALLATION
plug into a
15