Avoiding Remote Conflicts; Changing The Remote And Receiver Address - Dish Network 11 Quick Setup Manual

Instructions
2 Press the POUND (#) but-
ton twice. The mode button
flashes the number for each
digit of the equipment
code, with a pause between
the groups of flashes. A
quick flash is for zero.
For AUX mode, the first
group of flashes tells you
what the AUX mode
controls. A quick flash
(zero) before the three-digit
code is for a TV; one
regular flash is for a VCR
or DVD player; and two
flashes is for a tuner or
amplifier.
A R
VOIDING
Because your remote control uses UHF, you may experience
interference from other nearby remotes. The instructions in this section
describe how to avoid remote conflicts.
C
HANGING THE
One quick way to avoid remote conflicts is by changing the address on
your remote and receiver. If you notice that your receiver is changing
channels or opening menus but you're not using the remote control, a
quick change of address should fix the problem. Use these instructions
to change the remote control and receiver address.
1. Press SYSTEM INFO on the receiver's front panel. The System
Information screen displays and shows the Remote Address.
Write down the address shown:
2. Press and hold SAT on your remote control for about three
seconds, until all of the mode buttons light up, and then let go of
SAT.
8
C
EMOTE ONFLICTS
R
EMOTE AND
Additional Information
For example, if the code is 570,
the mode button flashes five
times, pauses, flashes seven
times, pauses, and flashes once
quickly.
For example, if the TV code is
570, the AUX mode button
flashes once quickly, pauses,
flashes five times, pauses,
flashes seven times, pauses, and
flashes once quickly.
R A
ECEIVER DDRESS