Indicator Installation - KUSSMAUL AUTO CHARGE 1000 PUMP-PLUS 091-9-1000 Instruction Manual

INDICATOR INSTALLATION

1. Locate Indicator in a convenient place on the vehicle.
2. Place the template in position and center punch in 4 places.
3. Drill holes as shown.
5. Cut out square hole.
6. Connect wiring to charger using butt connector supplied.
7. Install as shown.
8. Insert 4 #6-32 screws and tighten, (CAUTION Do not over tighten because
you will bend the plastic bezel and brake the watertight seal).
HOLE TEMPLATE