Philips SRC2063 User Manual page 4

3
L ook up the 4-digit
code for your brand
in the brand list at
the back of this user
manual.
A 4-digit code is
shown for each brand.
U se the digit
buttons to enter the
code for your brand.
• I f the red Setup
light turns off,
an invalid code
was entered. In this case, try again.
4
A im the remote
control at the TV.
Press and hold the
button. Release
it immediately as
soon as the TV
switches off.
• T his step normally takes between 5 and
60 seconds. In extreme circumstances
this step can take up to 15 minutes.
5
S witch ON the TV.
Try out the buttons
that you need for
operating it. Try, for
example, if the
- CH + and digit
buttons function properly.
• I f a button does not work as expected, press
and hold that button. Release it immediately
as soon as it works. For more information,
see chapter 2.2.2.
6
P ress the
device selection
button twice to
finish setup.
• W hen no
button is
pressed for 5 minutes or more, the
remote control will exit setup mode,
automatically saving all your settings.
6 EN
5-60 SEC.
5 - 60 sec.
2 x
Important
If you made a mistake:
• P ress the device selection button twice to
exit setup. The red Setup light turns off.
• Restart from the beginning.
• If the device does not respond at all or not to
all of the button commands or if you cannot
find the code for your brand, enter '9, 9, 9, 9' in
step 3 and continue with step 4. The remote
control will now search its full database for a
code that works with your TV. Full database
search may take up to 15 minutes.
2.2.1 Setting up the remote controls for
other devices (DVD player / recorder,
DTV, Cable / Satellite box, DVR and
VCR)
1
Make sure the device is switched on and
operational. E.g. insert a disc in the DVD
player / recorder or a video cassette in the
VCR (SRP2006 only).
2
T hen follow steps 2 to 6 of 'Setting up the
universal remote controls to operate your
TV'. Make sure to use the correct device
selection button:
- for SRP2003:
or
- for SRP2006: ,
2.2.2 Improving buttons
When correctly set up, the remote control
should be able to operate all your devices.
However, when using the remote control for the
first time it might occur that some buttons do
not yet function as expected.
In this case you can have the remote control
search for alternatives.
Note
Improving buttons is not possible when the
code was found during full database search
(with code '9, 9, 9, 9').
.
, , or .
EN 7