Troubleshooting - Sealey Sac5000 Manual

8. STORAGE
8.1. DISMANTLING THE PRODUCT WHEN OUT OF SERVICE
8.2. Switch off the unit and remove the electrical plug from it's power source.
8.3. Remove the window kit, exhaust hose and drain hose.
8.4. LONG TERM STORAGE
8.5. If you will not be using the unit for an extended period of time (more than a few weeks) it is best to clean the unit and dry it out
completely. Please store the unit per the following steps:
8.6. Drain the remaining water from the unit. See section 6.5.
8.7. Clean the filter and let the filter dry completely. See section 7.2.
8.8. Once the filter is dry re-install.
8.9. Store the unit and accessories in it's original packaging, upright in a safe dry childproof location.
8.10. Replace any drainage plugs.
8.11. Remove the batteries from the remote control.
NOTE: The evaporator inside the machine has to be dried out before the unit is packed to avoid component damage and molds.
Unplug the unit and place it in a dry open area for days to dry it out. Another way to dry the unit is turn on the machine, adjust it to low-
wind ventilation mode, and maintain this state until the drainage pipe becomes dry, so as to keep the inside of the body in a dry state
and prevent it from mildewing.
8.12. SPARE PARTS
8.12.1. Refer to the attached spare parts list.
8.13. DISPOSAL
8.13.1. Through years of normal wear, the unit will eventually become unserviceable. When this happens ensure that it is disposed of in
accordance with local authority regulations.
9.

TROUBLESHOOTING

SYMPTOM
The unit is not No power.
working.
Full water indicator is illuminated.
Low room temperature.
The unit works with Dirty air filter.
reduced capacity.
Air ducts are blocked.
Doors or windows open.
Incorrect mode and temperature selected.
Detached exhaust hose.
Water leakage. Spillage when moving the unit.
The drain hose is kinked or bent.
Excessive noise. The unit is on an uneven surface.
Loose, vibrating parts.
Water flowing sound.
Error E0 Communication faults between main PCB and
codes. display PCB.
E1 Ambient temperature sensor fail.
E2 Coil temperate sensor failures.
Ft Condensate water high level alarm.
© Jack Sealey Limited
POSSIBLE CAUSE
Original Language Version
REMEDY
Connect to power source and turn the unit ON.
Drain the water.
Change the set temperature.
Clean the air filter as required.
Clear obstacles. Re-position unit into clear space.
Close the doors and windows.
Select correct mode and temperature to suit desired application.
Securely reattach exhaust hose.
Empty the water tank before moving the unit.
Straighten the drain hose.
Place the unit onto a flat horizontal surface.
Check for loose parts and re-tighten.
Normal sound of refrigerant flowing.
Contact Sealey service centre.
Contact Sealey service centre.
Contact Sealey service centre.
Drain the water.
SAC5000, SACWK1 Issue 1 29/11/24