Advertisement
Contents
1. Use your digital camera to take photographs.
These photographs are stored internally in your digital camera.
2. Connect the digital camera to your PC, and install its
TWAIN source driver and control software.
Refer to the camera manufacturer's instructions for completing
these tasks.
3. Start the Pagis Scanner Setup Wizard from the Scan Tool
to select your camera's TWAIN driver.
For complete information, refer to "Setting up your scanner or
digital camera to work with Pagis Pro" earlier in this chapter.
For a digital camera, you must configure Pagis Pro to display and
use the camera's TWAIN dialog box.
4. Click the Scan icon on the Pagis ToolBar to display the
Scan Tool's Scanner tab (refer to Figure 4–14).
5. Select Photograph as the page type of the incoming image.
6. Optionally, click the Properties button to fine-tune
settings for the incoming image.
For example, you might want to turn on or off some of the page
refinement settings. Additionally, you might want to specify a file
name and location for the photograph. Finally, you might want to
add keyword search properties for the photograph to make it easy
to search on later. Refer to a previous section, "Changing default
properties for scanned documents," for complete information.
7. Specify Save and Close options on the Scan Tool.
The Auto Save checkbox is on by default. This automatically
saves the document to the default file name and location specified
in Auto Save properties. To display a standard Save As dialog box
when scanning is complete, click the Auto Save checkbox off.
Using Pagis Pro
Index
4–55
Advertisement
