Using Your Projector; Turning Your Projector On; Turning Your Projector Off - Dell M210X User Manual

Using Your Projector

Turning Your Projector On

NOTE:
Turn on the projector before you turn on the source (computer, DVD
player, etc.). The Power button light blinks blue until pressed.
Remove the lens cap.
1
Connect the power cord and appropriate signal cables to the projector. For
2
information about connecting the projector, see "Connecting Your Projector" on
page 8.
Press the Power button (see "Using the Control Panel" on page 18 to locate the
3
Power button).
Turn on your source (computer, DVD player, etc.)
4
Connect your source to the projector using the appropriate cable. See
5
"Connecting Your Projector" on page 8 for instructions to connect your source
to the projector.
By default, the input source of the projector is set to VGA-In. Change the input
6
source of the projector if necessary.
If you have multiple sources connected to the projector, press the Source
7
button on the remote control or control panel to select the desired source. See
"Using the Control Panel" on page 18 and "Using the Remote Control" on
page 21 to locate the Source button.

Turning Your Projector Off

NOTICE:
Unplug the projector after properly shutting down as explained in the
following procedure.
Press the Power button. Follow the instruction displayed on screen to properly
1
turn off the projector.
NOTE:
The "Press Power Button to Turn off Projector" message will
appear on the screen. The message disappears after 5 seconds or you can
press the Menu button to clear it.
Press the Power button again. The cooling fans continue to operate for 120
2
seconds.
14 Using Your Projector
3