Visioneer ROAD WARRIOR User Manual page 153

144 V S
ISIONEER TROBE
XP S U ' G
CANNER SER S UIDE
5. Insert the calibration page into the page feed.
The scanner grabs the paper and feeds it through the scanner.
The scanner will automatically pass the calibration sheet back and
forth several times.
Do not remove the sheet until calibration is finished.
6. When calibration or cleaning is complete, the page will back out of
the scanner.
If the page passes straight through and does not back out at the end
of the calibration, repeat the process.
Note: If scanned images or autocropped images still are of poor
quality after calibration, please call Visioneer Technical Support.
7. Close the Device Configuration Properties window, and remove
the calibration paper, or cleaning paper and replace it in its plastic
bag.
Note: Do not discard the cleaning paper. You can use it several times.
If additional cleaning is necessary, add a few drops of isopropyl
alcohol (rubbing alcohol) to the cleaning paper and use it again.
Note: If the calibration page is not available, you can use a piece of
blank white paper as a substitute. However, calibration will not be as
precise as with the regular calibration page.