Summary of Contents for Sony Microcassette M-100MC
Page 1
Record these numbers in the spacesprovided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model M-IOOMC Serial This device complies with Part 15of the FCC Rules. Operation is subject to the following two conditions:...
Page 2
Welcome! Thank you for purchasing the Sony Microcassette-Corder. Some features are: • The three modes (Lecture, Meeting, or Dictation) allow you to switch thé microphone sensitivity and directionality so fhat the microphone picks up the soundclearly depending on the recording situation.
Preparing Power Sources Chooseone of the following power sources. Dry Batteries Makesurethatnothingis connected to the DCIN 3Vjack. Open the battery compartmentlid. 2 Inserttwo R6(sizeAA) batteries with correctpolarity and close the lid. To take batteries...
Page 4
To attach the battery compartment lid, if it is accidentally detached Attach it as illustrated. When to replace the batteries Replace the batteries with new ones when the BATT indicators go off and the indicator flashes. The BATT indicators changeasillustrated: When batteries are new light...
Page 5
(EIAJ*) Recording Batteries Sony alkaline LR6 (SG) 16.0 Sony R6P (SR) • Measured value by the standard of EIAJ (Electronic Industries Assocration of Japan)(Using a Sony Microcassette MC-60) Note Thebatterylife mayshortendependingon theoperationof theunit. House current to the wall outlet DC IN 3V...
Page 6
stands Youcanpositiontheunit to recordthesoundmoreclearlyusing thestands. Y oucanchoose from thetwo typesof stands depending on the recording situation. Pull down the stand. Stand Insert the rubber stand attached Stand to the handstrap into the slot on the bottom of the unit.
Page 8
Press the reset button of the TAPE COUNTER. Press 41 and insert a standard microcassette with the side to start recording facing the lid. Selectthe desired tape spéed 2.4cm for optimum sound (recommended for normal use): A 30-minute recording canbe madeusing both sidesof the MC-30 microcassette.
Page 9
Press or slide Stop recording Start recording during during playback (the unit becomesin the recording mode) playback Ihe REC indicator lights. Review the portion just Slide toward recorded during the recording. Releaseit at the point to start playback. Pauserecording Slide IIPAUSE in the direct-ton of the...
Page 10
Using the MIC MODE selector Set MIC MODE to the desired position depending on the recording situation. Meeting Lecture Dictation To monitor sound Connectthe earphone(supplied to World model only) to EAR jack.The monitor volume cannot beadjustedby VOL To prevent a cassette from being accidentally recorded over Break out and remove the cassette tabs.
Recording cue marks While recording,you can record a specialsignal on the tape to mark a specific position. At the desired position, push CUE MARKER to record a signal. The RECindicator goesoff for a while and a signal will be recordedon the tape.If you want to record a signal longer than that, push CUE MARKER aslong asyou want.
Page 12
Press or slide Stop playback/stop fast forward or rewind* Slide IIPAUSE in the direction of the Pauseplayback arrow. The BAIT indicators go off. To releasepause playback, slide I IPAUSE in theoppositedirection. Slide toward Fast forward V*CUE during stop.• Slide toward Rewind during stop.••...
Page 13
Note If the tape is completely rewound while searchingbackward during playback (REVIEW), may not ret-umto the center positionwhen you release it. In this case, p ushit backto thecenter position to start playback. To increase the playback speed Slide the FAST PB switch in the direction of the arrow.
Page 14
Precautions On power • Operatethe unit only on 3 V DC. For AC operation, usethe AC adaptor recommendedfor the unit. Do not useany other type. For battery operation, usetwo R6 (size AA) batteries. On the unit • Useonly the (standard microcassettes) w ith this unit.
Troubleshooting Shouldany problempersistafteryou havemadethesechecks, consult your nearestSony dealer. A cassette cannot be inserted. —e The cassetteis being inserted in the wrong way. (The cassette should be inserted in the lid with the tape side facing upward.) has been already pressed cannot be pressed.
Page 16
Maintenance Head Capstan Pinch roller To clean the tape head and path Press and wipe the head,capstanand the pinch roller with a cotton swab, moistened with alcohol every 10hours of use. To clean exterior Use a soft cloth slightly moistenedin water. Do not usealcohol, benzine or thinner.
Need help?
Do you have a question about the Microcassette M-100MC and is the answer not in the manual?
Questions and answers