Printer Maintenance
The Printer Maintenance tab contains the System Settings, Paper Density,
Adjust BTR, Adjust Fuser, Color Registration Adjustment, Adjust Altitude,
Reset Defaults, Non-Dell Toner, BTR Refresh Mode, TCP/IP Settings, and
Network Settings pages.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
System Settings
Purpose:
To configure the power saving mode, time-out time, job log auto print, mm/
inch setting, operator panel language setting, default paper size setting, and
low toner alert message setting.
Values:
*1
Sleep
Deep Sleep
Fault Time-Out
Job Time-Out
*
5 minutes
5–30 minutes
*
6 minutes
1–6 minutes
0: Off
60 seconds*
3–300 seconds
0: Off
*
30 seconds
5–300 seconds
Specifies the time taken by the
printer before it enters Sleep
mode after it finishes a job.
Specifies the time taken by the
printer before it enters Deep
Sleep mode after it goes into
Sleep mode.
Disables the fault time-out.
Specifies the time taken by the
printer before it cancels jobs that
stop abnormally. The print job is
cancelled if it times out.
Disables the job time-out.
Specifies the amount of time that
the printer waits for data to arrive
from the computer. The print job
is cancelled if it times out.
Understanding the Tool Box Menus
201