10. Bundling the cables.
Follow the steps below to attach the cable clamp, an
accessory of the flat panel display.
1 ) Thread the clamp band through the holder and
bundle the cable(s) in the cable clamp.
2 ) Push and hold the levers then insert the hook into
an appropriate hole on the rear of the flat panel
3 ) Pull up the clamp band to lock.
4 ) Confirm that the cable clamp is seated firmly in the
Avoid pinching or creating pressure points when routing
or bundling cables.
To remove the clamp band, pull and hold the latch to
To remove the cable clamp, push and hold the levers
then pull it out from the hole.
The longer a clamp is in place, the better chance of
deterioration. An older clamp is more easily damaged
while being removed and may not be reusable.
Rear of flat panel display
When using the wall mount
First lay the flat panel display on top of a soft sheet etc., then
attach the speakers.
1. Attach the speakers to the flat panel
display (See procedures 1 to 10 on
pages 9 to 12).
Connect the other cables and power cord to the flat
2. Place the flat panel display on the
mounting fittings of the wall mount
For details, refer to the operating instructions supplied
with the wall mount unit.
Do not move the flat panel display by holding these
speakers or speaker brackets. This could result in injury
or damage to the brackets. When moving the flat panel
display, hold by the top and handles.
• Use a polishing cloth or dry cloth to wipe off dust and dirt.
• When the cabinet is very dirty, wipe with a soft cloth
moistened with water-diluted cleanser; then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
They may damage the surface of the cabinet.
• Never use thinner, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will
corrode the surfaces.
• When a chemical cloth is used, read the cautions for the
chemical cloth carefully.