TROUBLE-SHOOTING
Before calling for service, please read the following troubleshooting
your time and money. The table contains common problems except those caused by defects in
workmanship
or material of the refrigerator.
PROBLEMS
Freezer operation
The compressor
does
not work
The
freezer
runs
frequently
or runs for
too long period
Too high temperature
Too high temperature
inside product
Water / moisture
Moisture
accumulates
on the freezer's
outside
surface
CAUSES
Product is in defrosting cycle.
Freezer is not plugged
power outlet.
Product
is turned
OFF.
The indoor
or outdoor
temperature
is high.
The freezer
has been
powered offfor a period of
time.
The door is opened too
frequently
or for a long
period at one time,
0
The
door
of the
freezer
not tightly closed.
The temperature
setting is
too low,
I]
The door gasket is
dirty, worn, cracked or
mismatched.
The condenser is dirty.
I]
The
ventilation
around
freezer
is insufficient.
The door is opened too
frequently or for too long each
time.
Temperature is set too high.
The
door
is not
closed
tightly.
Condenser is dirty,
/ frost on outside
surface of the freezer
Damp climate.
The door
is not closed
tightly.
This causes
condensation
Of cold
the
freezer
and
the
outside
it.
This is normal for an automatic defrosting
freezer.
Check whether the plug, socket or fuse is
into a
damaged, Turn on the power when they are
0K.
Press the power button to start up the freezer
again.
In this case, it is normal for freezer to run
longer.
Normally, it takes 8 to 12 hours for freezer to
totally cool dowm
Warm
air enters
start frequently. Please do not open the door
too frequently.
Ensure the freezer is located on a level ground
is
and there is no food or container jarring the
door.
Set the temperature higher until a satisfactory
freezer temperature
hours for freezer temperature.
O
Clean or replace the door gasket. A leakage
gap ofdoor gasket can cause a longer running
time of freezer in order to maintain
the
temperature.
Clean
the condenser.
Check the ventilation
recommended
blocked by any objects.
Warm air will enter the refrigerator
the door is opened. Try to open the door as less
frequently
as possible.
Reset the temperature.
Ensure the freezer is located on a level ground
and there is no food or container
door.
Clean
the condenser.
This iS normal in damp climate.
The moisture will decrease when the humidity
drops.
air in
Make sure the ground is flat and no food or
containers
warm
air
closing fully;
table first. This can save both
SOLUTIONS
the freezer
and causes
is obtained.
It takes 24
space is the
size and check
it is not been
whenever
jarring the
are preventing
the door from
it to
desired
Need help?
Do you have a question about the HF-220WAA and is the answer not in the manual?