Maintenance; Cleaning The Exhaust Filter - Aeg Signum Bagless Instruction Manual

Cleaning the exhaust filter

Open the filter grill to remove the exhaust filter.
Takethe filter out of the grill and insert a new one.
Close the filter grill.
Exhaust filter reference number:
Replacing and cleaning the protection
filter and HEPA filter
1. Remove the dust container
2. a. There are two pre- motor filters in this
vacuum cleaner, a spongy grey protection
filter, and the framed
b. Remove the HEPA filter frame from the
container by pulling it away by the small tab.
Remove the grey protection filter by simply
pulling it loose from HEPA filter frame
c. Tap the HEPA filter face down on a flat
surface covered with a sheet of paper.
This will dislodge excessive residue from the
HEPA filter. Dispose of the cover sheet with
the dust residue. Gently beat the grey
protection filter in an open air space to
properly dislodge any dust.
Menalux F9000.
from the cleaner.
HEPA filter.
5.

MAINTENANCE

If necessary both the HEPAfilter and grey
3.
protection filter can be washed under a tap
with cold water. Always wash the filter from the
underside, do not scrub of use cleaning agents
on the filter.
4. Air dry both the HEPA filter and grey protection
filter for 24 hours to ensure it is completely
before reusing. Avoid direct sunlight or extreme
drying conditions.
Refit the grey protection
with the dust container and sitting it in place,
then fit the HEPA filter by alining the frame
with the dust container and simply sliding
the HEPAfilter into place.
6. If either of the filters appear damaged do not
re use them To purchase replacement filter call
Electrolux customer service
(AUS), 05 08 730 730 (NZ).
dry
filter by aligning it
on 1300 365 305