Lcd Cannot Be Seen At All; An Unintended Language Is Displayed On The Lcd - Canon PIXMA mini320 Series Manual

Note
Adjusting the Print Head Manually
If the Automatic Print Head Alignment does not work or if you wish to adjust the print head
manually, follow the procedure below.
1. Turn on the printer, and then load three sheets of Canon genuine 4" x 6" /
101.6 x 152.4 mm paper in the Rear Tray.
You can also load Canon genuine 5" x 7" / 127.0 x 177.8 mm paper to perform
Manual Print Head Alignment.
* Slide the Paper Guide against the left side of the paper stack.
* Use the Canon genuine 4" x 6" / 101.6 x 152.4 mm paper or Canon genuine 5" x 7"
/ 127.0 x 177.8 mm paper.
2. Select Settings on the Home screen, then press the OK button.
3. Select Maintenance, then press the OK button.
4. Select Manual head align, then press the OK button.
5. Select Yes, then press the OK button.
The Print Head Alignment pattern is printed.
The pattern is printed in black and blue only.
6. When "Did the patterns print correctly?" is displayed, confirm that the
pattern is printed correctly, then select Yes, and then press the OK button.
7. Check the printed patterns and use the [ or ] to input the number of the
pattern in columns A to E that has the least noticeable streaks, then press the
OK button.
8. Make sure that the paper is loaded, then press the OK button.
The second Print Head alignment pattern is printed.
9. In the same way, select the best patterns for columns F to H, then press the
OK button.
10.In the same way, print the third sheet and select the best patterns for columns
I to N, then press the OK button.
38 Troubleshooting

LCD Cannot Be Seen At All

Cause
The Printer is not If the Power lamp is off
powered on or the LCD is The printer is not powered on. Connect the power cord
in the screen-saver mode. and press the ON/OFF button. The printer will power
on and the LCD will display a message.
If the Power lamp is lit
On the Operation Panel, press a button the other than
the ON/OFF button.
An Unintended Language Is Displayed on the
LCD
Cause
The language you want to Select the language you want to be displayed
be displayed is not following the procedure below.
selected
(1) Press the HOME button. Wait for about 5
seconds, then select
button.
(2) Press the ] button to select
the OK button.
(3) Press the } button four times, then press the OK
button.
If the Bluetooth unit is connected to the printer,
press the } button five times, then press the OK
button.
(4) Press the { or } button to select the language
for the LCD, then press the OK button.
Action
Action
, and then press the OK
, then press