Viewing Vpn Attributes And Completing The Wizard - Cisco 515E - PIX Restricted Bundle Getting Started Manual

Chapter 4 Scenario: Site-to-Site VPN Configuration
Configuring the Other Side of the VPN Connection
Note
What to Do Next
78-17645-01
You have just configured the local security appliance. Now you need to configure
the security appliance at the remote site.
At the remote site, configure the second security appliance to serve as a VPN peer.
Use the procedure you used to configure the local security appliance, starting with
the "Configuring the Security Appliance at the Local Site" section on page 4-4
and finishing with the
section on page 4-11.
When configuring Security Appliance 2, enter the exact same values for each of
the options that you selected for Security Appliance 1. Mismatches are a common
cause of VPN configuration failures.
If you are deploying the security appliance solely in a site-to-site VPN
environment, you have completed the initial configuration. In addition, you may
want to consider performing some of the following steps:
To Do This ...
Refine configuration and configure
optional and advanced features
Learn about daily operations
Configuring the Other Side of the VPN Connection

"Viewing VPN Attributes and Completing the Wizard"

See ...
Cisco Security Appliance Command
Line Configuration Guide
Cisco Security Appliance Command
Reference
Cisco Security Appliance Logging
Configuration and System Log
Messages
PIX 515E Security Appliance Getting Started Guide
4-13