Site Access; Cover - Dimension One Spas Hot Tub User Manual

Site Access

Please refer to the drawings on pages 7 - 45 for the specifications and appropriate measurements for your hot
tub model. You will need the measurements of your hot tub in order to determine the clearance needed for
delivery.
DUE TO MANUFACTURING TOLERANCES THERE COULD BE SOME MINOR
DIFFERENCES BETWEEN THE ACTUAL MEASUREMENTS OF YOUR SPA AND THE
DRAWING BELOW. IF SITE PLANNING IS CRITICAL TO SUCH TOLERANCES, BE
Caution
SURE TO MEASURE YOUR ACTUAL SPA.
Your hot tub will probably be delivered on a dolly or cart. The additional distance from the ground to the
dolly or cart must also be included in your measurements for vertical clearance. Also, take into consideration
that if your hot tub must be transported up-hill or taken upstairs, you may need additional clearance or
assistance. Be sure to remove obstacles such as gates, planters, or items attached to the house. The point of
entry must be clear of air conditioning units, heating units, meters, electrical boxes, etc. It is best that your
dealer pre-inspect the installation site and determine the best way to deliver your hot tub. In rare cases, a
crane must be brought in to assist in an installation. Your Dimension One dealer will supervise this for you.
Here is a list of some of the most common installation hazards in planning your route:
Gates
Fences
Eaves
Gutters
Air Conditioners
Heaters

Cover

The cover supplied with your hot tub is
constructed of the highest quality
materials and is equipped with quick-
release keyed buckle locks that meet
standards set by American Standards
for Testing and Measurement (ASTM).
When the hot tub is not in use, it is
recommended that the cover locks
always be utilized to discourage
unsupervised use and to minimize heat
loss. When installing the cover on your
hot tub, be sure it is facing the correct
direction. When standing in front of
the topside primary control panel, the
center seam or hinge should run
horizontally. You should be able to lift
the handle of the cover and see the hot
tub control panel. Allow 18 inches of
extra space on the backside of the hot
tub where the optional E-Z Lifter
rest in its upright, open position.
2
2003 Dimension One Spa s and @ Home Hot Tubs
Planning Guide and Installation Manual
will
®
Hose Bibs
Bushes
Overhanging Branches
Steps
90° Turns