TJERNLUND HSUL,HST,HS115-J,1,2 POWER VENTERS (DISCONTINUED) 8506001 REV 1 1194 Manual

MOTOR SPECIFICATIONS

ELECTRICAL DATA

Volts 115
Hertz 60
RPM 3000
Watts 95
Amps 1.26
Therm. Prot. Yes

MECHANICAL DATA

DESCRIPTION

Shaded Pole Yes
Open Yes
Int. Fan Cooled Yes

CASING

Diameter (In) 3.33
Nom. Length (In) 4.50

SHAFT

Diameter (In) .313
Nom. Length (In) 2.25

BEARINGS

Type Sleeve
Material Sintered Iron

COMPONENT DESCRIPTION

Relay (Model HSUL-J only)
24/115V Switching Relay
Timer Relay (Model HST-J only)
Dual Voltage 24/115V input, 1-10 minute post
purge adjustment
Fan Proving Switch (All Models)
3 FLA, 18LRA @ 120V
-SIDE VIEW-
P/N 8506001
REV. 1 11/94
TJERNLUND PRODUCTS, INC.
1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE (800) 255-4208 • (651) 426-2993 • FAX (651) 426-9547
Visit our web site • www.tjernlund.com
HSUL-J, HS115-J & HST-J POWER VENTER SPECIFICATIONS

Performance curves

Static pressure (inches H2O) vs CFM (std. air) at selected flue gas temps.
NOTE: TO ARRIVE AT TOTAL SYSTEM STATIC PRESSURE REFER TO CURVE
AND ADD .38" TO COMPENSATE FOR VENT HOOD AND WIND RESISTANCE.
-END VIEW-
MODELS AND APPLICATION:
HSUL-J (Gas)
Used as a means of Side Wall Venting 24 volt
controlled appliances. This Power Venter
includes a 24/115 volt switching Relay and a
Fan Proving Switch.
HS115-J (Gas)
Used as a means of Side Wall venting 115 volt
appliances. This Power Venter DOES NOT
include a Switching Relay but still includes the
Fan Proving Switch.
HST-J (Oil or Gas)
Used as a means of Side Wall Venting 24 volt
or 115 volt controlled appliances which require
a Post Purge cycle. This Power Venter
includes a Post Purge Timer Relay and a Fan
Proving Switch.
Note: Tjernlund Products, Inc. reserves the
right to make changes to specifications without
notification.
-PLAN VIEW-