Keyboard Stand Assembly
Depending on the model of digital piano you
purchased, the surface color of one side of B may be
different from the other side. In this case, position B so
that the side of the surface color similar to D and E
faces the player.
2-1 Place the lower side of B on each foot of D and E,
then attach the upper side to D and E.
2-2 Attach the top of B to D and E by finger-tightening
the thin screws
2-3 While pushing the lower part of D and E from
outside, secure the bottom ends of B using two
2-4 Insert the other two tapping screws
into the other two screw holes to secure B.
2-5 Securely tighten the screws on the top of B that
were attached in Step 2-2.
of the rear
Securely tighten the screws on C that were
attached in Step 1-3.
YDP-161/141 Owner's Manual
(4 × 12mm).
(4 × 20mm).
(4 × 20mm)
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the illustration.
5-1 Adjust the position of A so that the left and right
ends of A will project beyond D and E equally
when seen from the front.
5-2 Secure A by tightening the short screws
(6 × 16mm) from the front.
Be sure to place your hands at least
10 cm from either end of the main unit
when positioning it.