Laser Beam Safety Precautions; How To Disassemble - Sanyo Cp8500 Service Manual

LASER BEAM SAFETY
(l) A Pick-upthat emits a laserbaamisused
in this compact disc player.
If the disc chuck lever is removed. the pick-up
exposed
Do not look •t the pick-up with the power switch ON.
DO not look directly .t the laser beam coming from the
pickop or allow it to strike •gatnst your fineers. skin.
etc.
DO not apply power if there is • broken part in the laser
section Of the pick-up.
K-UP REPLACEMENT
(1) When replacing the pick-up, carefully wipe away the
grease from the shafts
mounted.
(2) Replace the pick-up.
Move the pick-up to the position at the left side. and
(3)
then apply • coating of noil (G-474B) to the two
shafts.
Move the pick-up to the right side ond apply ftoil to
(4)
the remaining parts of the shafts.
HOW TO DISASSEMBLE
Remove the compact disc if there should be one on the
disc tray.
Switch the power OFF. and unplugthe AC powercord
from an AC outlet.
Disassemble in the numerical
Removal of mechanism
1.
Pull out the disc tray. as push @
Hook.
PRECAUTIONS
ton the surface
Of chuck
is
on which the pick-up is
THE UNIT
sequence.
and disc tray
The laser beam is emanated
(2)
shown in the fiwre.
O!SC
lever
When assemble the unit. set the gear as shown
re.nsert.ng the disc tray
Note:
from the location
BEAM A
I OOmm
SW p:cg
Fiwre 3 Mechanism Parts Location
F '9ure after
Match the lib of gear to the fourth
ditch of tie tray.