Connecting To A Terminal - Dell PowerConnect 3548 Getting Started Manual

Connecting to a Terminal

1 Connect an RS-232 crossover cable to the ASCII terminal or the serial connector of a desktop system
running terminal emulation software.
2 Connect the female DB-9 connector at the other end of the cable to the device serial port connector.
NOTE:
Do not connect the power cable to a grounded AC outlet at this time. You have to connect the device
to a power source in the steps detailed in Starting and Configuring the Device section.
Figure 1-3. Back-Panel Power Connector
Console Port
Console Port
RPS Connector
PowerConnect 3524/3548 Rear View
EPS Connector
PowerConnect 3524P/3548P Rear View
Power Connector
Power Connector
9
Installation