Electrical & Installation Requirements - Whirlpool Wht6030S Instructions Manual

here for installation, maintenance and suitable use of the product. The manufacturer further declines
all responsibility for injury due to negligence and the warranty of the unit automatically expires due to
improper maintenance.
• This device is not intended for use by persons (including children) whose physical, sensory or mental
abilities are different or reduced, or who lack experience or knowledge unless such persons receive super-
vision or training for the operation of the device by a person responsible for your safety.
• Children should be supervised to ensure they do not use the devices as a toy.
• Do not flame food under the kitchen hood.
• There must be adequate ventilation in the room, when the range hood is used at the same time
as appliances that consume gas or other fuels. (DOES NOT APPLY FOR RANGEHOODS THAT ARE ONLY
RECYCLING MODE).
• There is a risk of fire, if the cleaning is not carried out in accordance with the instructions.
• The discharge air must not be sent through a duct that is used to evacuate fumes from appliances that
consume gas or other fuels. (DOES NOT APPLY FOR RANGEHOODS THAT ARE ONLY RECYCLING MODE).
• Must be complied with regulations relate to the evaluation of the air discharge.
• In the event that your power cord is damaged in part or in full, do not try to repair it by contacting the
service center marked on your warranty or by a specialist technician for replacement.
• WARNING: Incorrect placement of screws or fasteners or mounting devices according to these in-
structions may result in electrical hazards.
• CAUTION: Accessible parts of the hood may become hot when used with cooking appliances.
ELECTRICAL & INSTALLATION REQUIREMENTS
Electrical requirements
IMPORTANT
Observe all local codes and ordinances.
It is the customer's responsibility: To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/
NFPA 70 — latest edition*, or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 -
latest edition** and all local codes and ordinances.
GROUNDING INSTRUCTIONS
- If codes permit and a separate ground wire is used, it is recommended that a qualified
electrician determine that the ground path is adequate.
- Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure range hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
- Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists
as to whether the appliance is properly grounded.
- This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current.
- WARNING : Improper grounding can result in a risk of electric shock.
ONLY FOR APPLIANCES PROVIDED WITH POWER SUPPLY CORD:
- This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and grounded.
- Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet
near the appliance.
- Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for
examination and/or repair.
- Do not run cord under carpeting.
- Do not cover cord with throw rugs, runners, or similar coverings.
- Do not route cord under furniture or appliances.
- Arrange cord away from traffic area and where it will not be tripped over.
IMPORTANT
Save Installation Instructions for electrical inspector's use.
- The range hood should be connected directly to the fused disconnect (Or circuit breaker).
5