Interference Statement - Dell Km3322W Quick Start Manual

United States, FCC Notices
FCC Radiation Exposure Statement
WARNING: The radiated output power of Dell
Bluetooth/wireless devices is far below the FCC
radio frequency exposure limits. Nevertheless, Dell
Bluetooth/wireless devices should be used in such
a manner that the potential for human contact during
normal operation is minimized.
This device has also been evaluated for and shown compliant with
the FCC RF exposure limits under portable exposure conditions
(antennas are within 20 cm of a person's body) when installed
in certain specific OEM configurations. Details of the authorized
configurations can be found at
Fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
by entering the FCC ID number on the device.

Interference Statement

This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
manufacturer's instruction manual, may cause interference with radio
and television reception. This equipment has been tested and found
to comply with the limits for a Class B digital device pursuant to Part
15 of the FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: The FCC regulations provide that changes or
modifications not expressly approved by Dell Inc. could
void your authority to operate this equipment.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference with
radio or television reception, which can be determined by turning
the equipment off and on, you are encouraged to try to correct the
interference by one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the system with respect to the receiver.
• Move the system away from the receiver.
• Plug the system into a different outlet so that the system and the
receiver are on different branch circuits.
If necessary, consult a representative of Dell Inc. or an experienced
radio/television technician for additional suggestions.
NOTE: Dell Bluetooth/wireless devices must be
installed and used in strict accordance with the
manufacturer's instructions as described in the user
documentation that comes with the product. Any other
installation or use will violate FCC Part 15 regulations.
Modifications not expressly approved by Dell could void
your authority to operate the equipment.