Supplied Accessories; Names And Functions Of Components; Attaching/Detaching The Lens - Panasonic H-Hsa35100 Operating Instructions Manual

• To prevent dust and other particles from accumulating
on or entering the lens, attach the lens rear cap when
the lens is not in use.
• To protect the lens contact points 1, do not place the
lens with its mount surface facing down. In addition, do
not allow the lens contact points to become dirty.
(See illustration
∫
About Condensation (Fogging of the Lens)
• Condensation occurs when there are differences in
temperature and humidity as described below.
Condensation can cause the lens to become dirty and
lead to mold and malfunctioning, so exercise caution in
the following situations:
– When the camera is brought indoors from outside
during cold weather
– When the camera is brought into an air-conditioned car
– When cold air from an air conditioner is directly blown
onto the lens
– In humid places
• If condensation occurs, turn the power off and leave it for
about two hours. Once the camera acclimatizes to the
surrounding temperature the condensation will go away
naturally.
B

Supplied Accessories

Product numbers correct as of January 2017. These may
be subject to change.
1
Lens Pouch
2
Lens Cap
3
Lens Rear Cap
4
Lens Hood
• The lens rear cap and lens cap are attached to the
interchangeable lens at the time of purchase.
C

Names and Functions of Components

1
Lens surface
2
Focus ring
Rotate to focus when taking pictures with manual
focus (MF).
3
Zoom ring
Rotate the zoom ring when you wish to take large
(tele) or wide (wide angle) pictures.
4
[O.I.S.] switch
When the lens is attached to the camera the stabilizer
function is set to activate if the O.I.S. switch is set to [ON].
• We recommend setting the O.I.S. switch to [OFF]
when using a tripod.
5
Contact points
6
Lens fitting mark
7
Lens mount rubber
Note
• If you zoom after focusing, focusing errors may occur.
After zooming, please perform the focusing again.
• In very quiet situations Auto Focus operating sounds
may be recorded during motion picture recording. This is
not a malfunction. In such situations, switching to
Manual Focus will improve the situation.
• If you set the O.I.S. to [ON] when recording a motion
picture, operating sounds may be recorded. If they
become bothersome, we recommend setting the O.I.S.
switch to [OFF] and mounting the camera on a tripod.
D

Attaching/Detaching the Lens

For information on how to attach and remove the lens,
refer to the operating instructions for your digital camera.
• Before attaching or detaching the lens, check that
the digital camera is turned off.
• Before attaching the lens to the digital camera, remove
the lens rear cap A by rotating it in the direction of the
arrow. (See illustration
• To prevent dust and other particles from accumulating on
or entering the lens, be sure to attach the lens cap/lens
rear cap after detaching the lens from the digital camera.
∫
Attaching Filters
• Vignetting may occur if using 2 or more filters at the same time.
• It is possible to attach the lens cap with the filter already attached.
• When using the lens hood and a filter at the same time,
attach the filter first.
• You cannot attach a conversion lens or adaptor to this
lens. A filter may be used, but attaching any other
element may cause damage to the lens.
∫
Attaching the Lens Hood (Supplied Accessory)
(See illustration
1
Align the mark B (
the mark on the tip of the lens.
2
Rotate the lens hood in the direction of the
arrow until it clicks and then align the mark
C (
the tip of the lens.
∫
Temporarily Storing the Lens Hood
(See illustration
1
Turn the lens hood in the direction of the
arrow to detach it.
2
Reverse the lens hood and then attach it in
the same way as shown previously.
Note
• When taking pictures with the flash with the lens hood
attached, the lower portion of the screen may turn dark
(vignetting effect) and the control of the flash may be
disabled because the photo flash may be obscured by
the lens hood. We recommend detaching the lens hood.
)
) on the lens hood with the mark on
)
)
) on the lens hood with
)