Philips AVENT SCD520 - Avent DECT Baby Monitor Monitoring System User Manual page 13

5 Leave the parent unit in the charger until the battery pack is fully
charged.
, During charging, the charging light on the charger lights
up continuously.
When the battery pack is fully charged, the display of the parent unit
,
shows a full battery symbol T .
- When you charge the parent unit for the fi rst time or after a long
period of disuse, switch it off and let it charge continuously for at least
10 hours.
- Charging normally takes 8 hours, but it takes longer when the parent
unit is switched on while charging. To keep the charging time as short
as possible, switch off the parent unit during charging.
- When the battery pack is fully charged, the parent unit can be used
cordlessly for at least 24 hours.
Note: When the parent unit is charged for the fi rst time, the operating time
is less than 24 hours. The battery pack only reaches its full capacity after you
have charged and discharged it four times.
Note: When the parent unit is not connected to a power outlet or even when
the parent unit is switched off, the battery pack gradually discharges.
Using the appliance
Use the baby monitor for its intended household use as described in this
manual.
1 Place the parent unit and the baby unit in the same room to test the
connection.
Make sure the baby unit is at least 3 feet/1 meter away from the parent
unit.
2 Press and hold the on/off button 3 on the baby unit until the green
power-on light goes on.
Note: The power-on light always lights up green, even when there is no
connection with the parent unit.
, The nightlight lights up briefl y and then goes out again.
, The battery light T lights up briefl y and then goes out again.
ENGLISH
13