Removing The Unit; Installing The Microphone Unit - Kenwood DDX318 Installation Manual

Removing the Unit

1
Remove the escutcheon by referring to
the removal procedure in the section
<Removing the Escutcheon>.
Insert the two removal tools 6 deeply into
2
the slots on each side, as shown.
3
Lower the removal tool toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
⁄
• Be careful to avoid injury from the catch pins on
the removal tool.
4
Pull the unit all the way out with your
hands, being careful not to drop it.

Installing the Microphone Unit

(DDX418/DDX4048BT only)
1
2
3
Accessory 6
4
⁄
• Install the microphone as far as possible from the
Peel the release coated paper of double-face
adhesive tape to fix on the place shown above.
Adjust the direction of the microphone to the driver.
Check the installation position of the
microphone (accessory 7).
Remove oil and other dirt from the
installation surface.
Install the microphone.
Wire the microphone cable up to the unit
with it secured at several positions using
tape or the like.
cell-phone.
Accessory 7
Fix a cable with a commercial item of tape.
7
English