Dell PowerVault MD3600f Installation Manual page 12

• To enable or disable service location protocol (SLP):
# cimconfig -s slp={true | false} -p
If SLP is enabled, see Table 2-1 for additional settings information.
Commands are of the following format
cimconfig -s <propertyName>={true|false} -p
where <propertyName> is a column heading in Table 2-1.
Table 2-1. Additional Setting Information if SLP is Enabled
runinternal registerExternal
PegasusSL PegasusSLP
P
true false
false true
false false
false false
false true
NOTE:
All other combinations of the SLP property values have undefined behavior.
For more information, see the documentation available in the source release
archive at openpegasus.org.
12
Installing and Uninstalling the SMI-S Provider
propertyName
registerExternal
OpenSLP
false
false
true
true
false
register
Multiple
SLP
false Internal Pegasus SLP is started
when cimserver starts.
false External Pegasus SLP
registration runs in cimserver
with a default registration
timeout set to 3 hours (same
as the SLP default timeout).
false External OpenSLP registration
is run in CIM server.
true External OpenSLP registration
is attempted and falls back to
external Pegasus SLP
registration if it fails (default
setting).
true External Pegasus SLP
registration is attempted and
falls back to external OpenSLP
registration if it fails.
Behavior