Automatic Configuration; Manual Configuration - Dell PowerVault MD3000i User Manual

performed in the department: Accounts Receivable (AR), Accounts Payable
(AP), internal billing, and so forth. In this scenario, the AR and AP virtual
disks probably need more capacity than the internal billing virtual disk.
NOTE:
In Linux, the host must be rebooted after deleting virtual disks to reset the
/dev entries.
NOTE:
Before you can use a virtual disk, you must register the disk with the host
systems. This process is described in "Host-to-Virtual Disk Mapping" on page 60.

Automatic Configuration

If you want to set up virtual disks quickly, click the Configure tab and then
click Automatic Configuration. With this option, you do not need to
configure individual options for each virtual disk. When you use automatic
configuration:
• All available unconfigured capacity on the array is used.
• All disk groups have the same RAID level.
• All virtual disks have equal capacity.
• The number of virtual disks created is based on the selected RAID level
and available unconfigured capacity.
• For a RAID level 1, 5, or 6 disk group, hot spare drives are selected
automatically based on the number of drives and types of drives available
in the storage array.

Manual Configuration

To create individual virtual disks or disk groups, click the Configure tab and
then click Create Virtual Disks. You create one disk group and virtual disk at
a time, but have control over the RAID level and capacity for each virtual disk
and disk group. Use this method if you have unique capacity requirements for
a disk group or virtual disk.
Creating a Disk Group and Virtual Disk From Unconfigured Capacity
Use the following procedure to manually create a disk group:
1 Click the Configure tab, then click Create Virtual Disks.
2 Select Unconfigured capacity on the Create Virtual Disks – Select
Capacity Type page, then click Next.
Disk Groups and Virtual Disks
55