HP 1606 Release Note page 40

Closed fixes summary
On Editing the view, there is a mismatch between the levels set under
the Manage view option in View menu and the levels shown in device
tree.
Flyover is not displayed between the created new storage array and
switch.
Able to create two or more New servers/Storage arrays with same
name as a fabric name and error message is not shown.
Created storage array entry persists even after the corresponding
fabric is unmonitored.
Disconnect button is enabled when there is no selection of active client
in Active Session dialog box. If Disconnect is clicked, active client is
not removed from the dialog box but actually client is disconnected
with no masterlog message.
Active TI zone is shown with green icon in Activate Zone Config dialog
box for Fabric OS less than 6.2.0.
Enabling a tunnel failed with the message Tunnel Admin Status cannot
be set. error: failed to modify.
Not able to manage the switch in server A although the fabric is un-
monitored in server B.
Fabric changes cannot be accepted due to Access Gateway collector
run before switch creation. When an Access Gateway-capable device
newly joins the fabric, the device type is not updated with an Access
Gateway icon in the Connectivity Map and user will not be able to
perform the "Accept Changes" operation.
Fabric port report is not showing the details in fabric section in Linux
OS.
Switch Model Number is always shown as Brocade 200e in Email
Call Home Content when switch is in AG Mode, regardless of the
switch model.
Active zone Configuration is not getting updated when the zone is
enabled from CLI for the Fabric OS 6.1.2 seed switch.
Event description is not available in Call home centers.
Edge fabric is not shown in LSAN Zoning dialog box.
40
Solution
Workaround prior to upgrade: Reset
the levels under the Manage view
option in view menu.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Workaround prior to upgrade: Close
and re-launch the client.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Workaround prior to upgrade:
Rediscover the fabric.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Workaround prior to upgrade: Delete
the unmonitored fabric and reopen
the LSAN Zoning dialog box.
Fixed in DCFM 10.4.0.