HP 1606 Release Note page 39

Closed fixes summary
In Email Event Notification some events are missing in email when
Summary Interval is configured for 5 seconds.
After Migration for the Interopmode 3 fabric, user is not able to activate
a WWN zone config from the Global zone library if any D,P member
is present in different zone configuration.
IP address updated in the remote client is not getting updated in the
local client and the switch is also not getting manageability.
Renamed TI zone is shown as active in the active zone configuration
tab for Fabric OS 6.2.x.
Manageable switch is missing from the FCIP Tunnel dialog box, even
though the FCIP collection is completed.
Active TI zone is shown with green icon in Compare Merge dialog
box for Fabric OS less than 6.3.0.
Decimal values are not shown in Historical Report for Tx or Rx %Utiliz-
ation when it is selected as Main Measure.
Different values are shown in Historical Graph and Report for Rx or
Tx MB/sec in 30 minutes Granularity.
For a fabric with phantom switch, on discovering the fabric or creating
a new view with the fabric or adding the fabric to a view, the Connec-
ted end devices is set to hide all, but the phantom switch is shown in
device tree.
Syslog unregistration did not happen for Host Deletion in HBA Man-
agement.
The Virtual devices are counted in the device information area in fabric
summary report so that number of Initiator, Target count shown incor-
rectly.
On editing the view name without editing the selected fabrics and
hosts, the end devices are hidden in topology, even though "show all"
is still selected.
Only Rx Ave MB/sec is shown instead of Tx + Rx Ave (MB/sec) as
the column header in Top Talkers dialog box in Fabric mode.
Fabric Port Report's "Total Port count" is adding GigE port count also.
B-series Data Center Fabric Manager Enterprise, Professional Plus, and Professional
Solution
Fixed in DCFM 10.4.0.
Workaround prior to upgrade: User
has to delete all the zones which
contain D,P members from the Global
zone Library.
Fixed in DCFM 10.4.0.
Workaround prior to upgrade: Open
a new local client after 5 Minutes.
Fixed in DCFM 10.4.0.
Workaround prior to upgrade: Wait
for a discovery cycle.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Workaround prior to upgrade: After
discovering or creating the view with
the fabric or adding the fabric to the
view, select the desired sub-option in
the Connected devices option.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Workaround prior to upgrade: Under
Connected end devices , select Hide
all and then show all.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
Fixed in DCFM 10.4.0.
39