HP 1606 Release Note page 25

By default, the Management application SMI Agent is configured to advertise itself as a Service Agent
(SA). The advertised SLP template shows its location (IP address) and the WBEM Services it supports.
The default advertised WBEM services show the Management application SMI Agent:
Accepts WBEM requests over HTTP without SSL on TCP port 5988
Accepts WBEM requests over HTTPS using SSL on TCP port 5989
slptool commands
Use the following slptool commands to determine whether the SLP is operating properly.
slptool findsrvs service:service-agent
Use this command to verify that the Management application SMI Agent SLP service is properly
running as a Service Agent (SA). Example output: service:service-agent://
127.0.0.1,65535.
slptool findsrvs service:wbem
Use this command to verify that the Management application SMI Agent SLP service is properly
advertising its WBEM services. Example outputs: service:wbem:https://
10.0.1.3:5989,65535 and service:wbem:http://10.0.1.3:5988,65535. This output
shows the functionalities of Management application SMI Agent:
Accepts WBEM requests over HTTP using SSL on TCP port 5989
Accepts WBEM requests over HTTP without SSL on TCP port 5988
slptool findattrs service:wbem:https://<IP_Address:Port>
Use this command to verify that Management application SMI Agent SLP service is properly ad-
vertising its WBEM SLP template over the HTTP protocol. Example output:
slptool findattrs service:wbem:http://10.0.1.2:5988
NOTE:
IP_Address:Port is the IP address and port number that display when you use the slptool
findsrvs service:wbem command.
slptool findattrs service:wbem:https://IP_Address:Port
Use this command to verify that the Management application SMI Agent SLP service is properly
advertising its WBEM SLP template over the HTTPS protocol. Example output: slptool findat-
trs service:wbem:https://10.0.1.2:5989
SLP on UNIX systems
This section describes how to verify the SLP daemon on UNIX systems.
SLP file locations on UNIX systems:
SLP log Management_Application/cimom /cfg/slp.log
SLP daemon Management_Application/cimom /cfg/slp.conf
You can reconfigure the SLP daemon by modifying this file.
SLP register Management_Application/cimom /cfg/slp.reg
You can statically register an application that does not dynamically register with SLP using SLPAPIs
by modifying this file. For more information about these files, read the comments contained in
them, or go to http://www.openslp.org/doc/html/UsersGuide/index.html.
B-series Data Center Fabric Manager Enterprise, Professional Plus, and Professional 25