Connecting the adapter to other devices
The cables that are required to connect the adapter to other devices are provided with most HP server products
that need them. Table 1 lists some cables that can be used with this adapter. All HP cables are keyed so that they
cannot be installed incorrectly.
Table 1
Cable kit part numbers
Type of cable
Internal SAS/SATA
Internal SAS/SATA
Internal SAS/SATA
Internal SAS/SATA
Internal SAS/SATA
Internal SAS/SATA
You can order extra cables from an authorized HP reseller or authorized HP service provider. If the cable that
you need is not listed here, or if you need additional ordering information, see http://www.hp.com.
Completing the adapter installation procedure
1.
Verify that all cables are routed correctly and are not restricting or being pinched by other components. For
the correct routing of the cables, see the server documentation.
2.
Reconnect any peripheral devices to the server.
3.
Plug the AC power cord into the server, and then into a grounded AC outlet.
4.
Power on any peripheral devices attached to the server.
5.
Power up the server.
6.
If necessary, update the server ROM. The required firmware files are on either a CD in the adapter kit or
the HP website, http://www.hp.com. Instructions are provided with the files (in the case of the CD, in a
booklet provided with the CD).
7.
Install the adapter drivers. The drivers are also on either the CD in the adapter kit or the HP website, and
instructions are again provided with the files.
Description
Multi-lane A cable
Host fan cable
Target fan cable
Multi-lane B cable
Multi-lane 76-cm (30-in) cable
Multi-lane 48-cm (19-in) cable
Part number
389647-B21
389650-B21
389653-B21
389659-B21
389662-B21
391330-B21
Installation procedure 6