Table of Contents
Advertisement
INSTALLER
INSTALLATION MENU
Power Management (cont'd)
7. POWER OFF CMD –
(OfCmd)
8. COMMAND TYPE –
(CmdTp)
a. Selected: Learned IR
i. LEARNED SRC –
(LnSrc)
b. Selected: Unassigned
c. Selected: Default
d. Selected: Macro:
i. MACRO –
(Macro)
ii. MACRO ID –
(MacID)
e. All Other Selections:
9. DEVICE CODE –
(DevCd)
10. KEY FUNCTION –
(KyFn)
11. SAVE CHANGES? –
(Save?)
LEARN IR (LrnIR)
This procedure allows IR commands to be learned into the system and be centrally stored in the main
controller to let the system access the same IR codes that operate the source equipment.
NOTE: IR codes must be learned in pointing the source's remote control at the CAV6.6's front panel
IR receiver. Use a keypad connected to the CAV6.6's front panel programming port for convenience
in navigating the Learn IR procedure menu. See Installation Menu on Page 55 and Learn IR -
Flow Chart on page 75
64
Tells the controller to turn off the selected source equipment (by
SOURCE NUMBER) when the last of the UNO System Keypads is
turned off. If "no," procedure advances to SAVE CHANGES (step 11)
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
(LrnIR)
not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 10)
The Power Off command is cleared. Procedure advances to
(Unasg)
SAVE CHANGES (step 11)
Default selects the same device type and device code previously
(Deflt)
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 10)
(To build macros, see Macro Editor page 65)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number.Menu advances to SAVE CHANGES
(step 11)
Procedure advances to DEVICE CODE (step 9)
Source component code for IR control.
Select Keypad function.
Select "yes" to save the changes.
Advertisement
Table of Contents
