Table of Contents
Advertisement
2. KEY FUNCTION –
(KeyFn)
3. LEARN/DELETE –
(Ln/Dl)
4. TEST IR? –
(TstIR)
5. SUCCESS? -
(OK?)
MACRO EDITOR (MacEd)
This procedure is used to create a sequence of commands that are launched with one key touch or
other event. Up to 132 macros can be created for the system, and each macro can contain up to 10
commands including other macros and delays. See Macro Editor - Flow Chart page 78
1. MACRO ID –
(MacID)
2. MACRO NAME –
(MacNm)
3. COMMAND NUM –
(Cmd#)
4. COMMAND TYPE –
(CmdTp)
a. Selected: Learned IR
(LrnIR)
i. LEARNED SRC –
(LnSrc)
Select the function to be learned or deleted.
Select Learn IR Now or Delete IR. If Learn IR Now, a "USE
REMOTE" prompt appears. Point the learning remote at the
controller's IR window. If Delete IR, procedure returns to
LEARNED SRC (step 1)
If "yes," sends the learned command to the source component
to test the IR. If the component responds, the IR test was a
success. If the component does not respond the Code was not
learned properly. If "no," menu goes back to LEARNED SRC
(step 1)
Asks if the IR test was a success
IF YES - If the test was a success, specify "yes" and proceed to
KEY FUNCTION (step 2)
IF NO - If the test was a failure, specify "no" and LEARN/DELETE
(step 3) reappears on the display allowing another code to be
learned in.
Number of Macro up to 132 including any previously named
macros.
Name of Macro (optional).
Number of Command up to 10.
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 6)
INSTALLER
INSTALLATION MENU
65
Advertisement
Table of Contents
