Review this manual before oper- ating deep cleaner. Record and Retain This HOOVER deep cleaner is designed for deep cleaning of carpet, and rugs. It can also be used to clean carpeted stairs and upholstery. GROUNDING PIN The model and serial numbers are located on the data label on the back of the deep cleaner handle.
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer.
Assembling deep cleaner The assembled cleaner will look like this drawing. Push bolts into holes on front of handle (Fig. 4). If bolts will not go through hole easily handle is not pushed completely down. Place nuts in recessed areas on back of handle. Hold each Attach upper handle nut in place while tightening each bolt securely with a Phillips screw driver (Fig.
Page 4
HANDLE NOZZLE CONNECTOR CLIP 1 CORD HOOK CLIP 1 Press cord into cord clip on back of handle. Pull cord tightn (Fig. 8). Attach lower hose holder To store hose on rack, begin by placing nozzle connector end HOSE of hose (straight end) into clip 1 on rack (Fig. 12). HOLDER PROJECTIONS HOLES...
Deep cleaner description The assembled deep cleaner will look like the drawing below. TAB (A) The nozzle is stored in the area between the cord hooks (Fig. 15). Place brushes of nozzle on top of Tab (A) as shown. Gently push the nozzle downward while pivoting it into the nozzle holder (B).
To transport General operation Turn deep cleaner off before transporting. Operate deep cleaner only at voltage specified on data plate on back of cleaner. ON/OFF pedal ON/OFF PEDAL To move your deep cleaner from room to room, put handle in upright and locked position, tilt deep cleaner back on wheels, and push forward.
There are three reasons why the brushes may not be rotating: For carpet and carpeted stairs: 1. Brush speed selector set on OFF. (See previous section.) Fill cap to upper “carpet” fill line (5 ounces) with HOOVER 2. Solution tube connected (page 12). Carpet/Upholstery Detergent.
REAR OF TANK Replace cap. Rotate cap clockwise until it locks in place. Cap must be locked in place for proper performance and to Unlatch back part of tank lid and remove lid. prevent leaking. Empty tank. Pour dirty water out from the rear of the tank. For full suction, it is important that the recovery tank lid is properly secured before cleaning.
For upholstery, check cleaning code - Use your slides or wood finishes will not stain the carpet. HOOVER ‘SteamVac’ deep cleaner only if the upholstery b. If desired, the carpet may be rinsed. Rinsing is not fabric is marked with a “W” (for “wet” clean) or “S/W” (for necessary for cleaning, but it may improve the surface’s...
Cleaning carpet Picking up spills Your HOOVER ‘SteamVac’ deep cleaner may also be used to Read “Before you begin cleaning” instructions on page 9. pick up small liquid spills (1 gallon or less, never to exceed inch in depth) on carpet, upholstery, or bare floors.
Do not use the 'SteamVac' deep cleaner on hardwood floors. Fill clean solution tank according to instructions on pages 7 and 8. Use 5 ounces of HOOVER Bare Floor Cleaner. Do not use any type of wax with your ‘SteamVac’ deep cleaner.
Page 12
For full suction, it is important that the recovery tank lid is properly secured before cleaning. FRONT PANEL TABS Remove recovery tank front panel by sliding it straight up. FRONT The tank lid is replaced in a hinge-like manner. Position front of lid under tabs on front of tank.
Disconnect hose and solution tube from deep cleaner. Fill clean solution tank according to instructions on pages 7 and 8. Use 5 ounces of HOOVER Carpet/Upholstery Detergent. Hose length may require that machine be placed at the top of the stairs to clean upper half of stairway and at bottom of stairs to clean lower half.
Be sure to check the cleaning code on your upholstery. Use • Replace empty solution tank and turn deep cleaner your HOOVER ‘SteamVac’ deep cleaner only on upholstery ON. Squeeze trigger and push deep cleaner forward marked “W” or “W/S”.
3. Replace fuse/reset (U.S. only). breaker. breaker. Do not send your cleaner to The Hoover Company in Low suction North Canton for service, this will only result in delay. 1. Recovery tank lid not 1. Make sure lid is on If further assistance is needed, contact The Hoover on correctly.
Page 16
HOOVER and are registered trademarks THE HOOVER COMPANY, NORTH CANTON, OHIO 44720 R1 8-96 F5853-/57-/61-/63-900 Litho USA 56518-086...