Assembling Deep Cleaner - Hoover SteamVac F5807 Owner's Manual

Assembling deep cleaner

Assembled models without
attached tools will look like
this drawing.
Attach upper handle
1
Remove clean solution tank
(upper tank) (Fig. 1).
3
With cord hook to back of deep cleaner, push
upper handle down onto lower handle. (Fig.3).
Assembled models with
attached tools will look
like this drawing.
2
(B)
Remove nozzle stored on upper
handle by gently pushing nozzle
downward while pivoting it away
from the handle at (B).
CORD
HOOK
4
Push bolts into holes on front of handle (Fig. 4).
If bolts will not go through hole easily handle is not pushed
completely down.
5
Place nuts in recessed areas on back of handle. Hold each
nut in place while tightening each bolt securely with a Phillips
screw driver (Fig. 5).
Only two nuts are needed on this model. The extra nut is not
required but has been provided for your convenience.
6
When handle sections are completely together, squeeze
trigger on upper handle to snap trigger rod in place (Fig. 6).
7
TANK
HANDLE
Replace clean solution tank (upper tank) by positioning bottom
first. Press on tank handle to snap top of tank into place (Fig. 7).
SQUEEZE
TRIGGER
Continued
Assembly
3