Chapter 2, Fabric Watch Thresholds; In-Between Buffer Values; Chapter 4, Fabric Watch Activation - Brocade Communications Systems 8 Documentation Update

5

Chapter 2, Fabric Watch Thresholds

Chapter 2, Fabric Watch Thresholds
On page 15 and 16, the sections "High and low thresholds" have been changed to include the
following expanded threshold categories:
•
•
•
•
NOTE
The above low threshold action applies only to the portThConfig command. It does not apply to the
thConfig and sysMonitor commands.

In-between buffer values

The below high threshold is the term used to configure "in between" buffer values, as shown below.
In this example, the high threshold value is 5 and the buffer value is 1. Therefore, the "in-between"
boundary value is 4. Enter the portThConfig command using the following parameters.
portthconfig
_______________________________________________________________________________
_______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________

Chapter 4, Fabric Watch Activation

On page 30 "snmpConfig -set" should appear as "snmpConfig --set".
16
Above high threshold
Below high threshold
Above low threshold
Below low threshold
--
set port -area crc -highth -value 4 -trigger below -action raslog
Above high threshold
Below high threshold
Above low threshold
Below low threshold
Above action = 5
BUFFER = 1
Low action
In-between
Above action
BUFFER
Low action
Fabric OS Documentation Updates
53-1002063-03