Gathering additional information
The following commands should be executed and their data collected before a supportsave is run.
A supportsave can take 10 minutes or more to run, and some of the information is time critical.
NOTE
The portshow -perf and - params options can be applied only to the 7500 switch and FR4-18i blade.
For issue specific to tunnel ports, run and collect the data from the following commands:
If possible, run and collect the data from the following commands:
And finally gather the data from the supportSave -n command.
See Fabric OS Administrator's Guide or Fabric OS Command Reference for complete details on
these commands.
Fabric OS FCIP Administrator's Guide
53-1001766-01
•
traceDump -n
•
portTrace --show all
•
portTrace --status
•
slotShow
•
portShow [slot number/]<geport number>
•
portShow ipif [slot number/]<geport number>
Displays IP interface configuration for each GbE port (IP address, gateway and MTU)
•
portShow arp [slot number/]<geport number>
•
portShow iproute [slot number/]<geport number>
•
portShow fciptunnel [slot number/]<geport number> <all | tunnel ID>
Displays complete configuration of one or all of the FCIP tunnels
•
portShow fciptunnel -all -params
•
portShow fciptunnel -all -perf
•
portShow fciptunnel -all -credits
•
portCmd <--ping |--traceroute |--perf >
•
Ping and traceroute utility
•
Performance to determine path characteristics between FCIP endpoints
4
FCIP links
95