Dell 8 Getting Started Manual page 5

Overview
This Getting Started Guide is intended as an overview to help experienced installers unpack, install, and configure
the Dell M8428-k quickly. For detailed installation and configuration instructions, see the Dell M8424-k Hardware
Reference Manual.
NOTE
Throughout this document, the Dell M8428-k is referred to as the converged network switch or the switch module. It
is also called the M8428-k 10GbEE-FCOE/8Gb FC SW.
Unpacking and installing the converged network switch
If the converged network switch is installed in the Blade Server Enclosure that is shipped to you, skip this section.
This section applies when installing a new module in an empty bay or replacing an existing converged network
switch.
NOTE
The converged network switch is designed to work in I/O bays B1/B2 and C1/C2 of the Dell M1000e Blade Server
Enclosure for SAN connectivity. Make sure to comply with installation requirements in the Blade Server Enclosure
Hardware Owner's Manual.
Perform the following steps to remove the switch module from its shipping package.
1. Open the shipping box and inspect the contents, making sure that nothing is missing or damaged.
Do not insert a damaged converged network switch into the Blade Blade Server Enclosure. If the switch module
appears to be damaged, contact your sales representative before proceeding.
2. Remove the cardboard accessory tray from on top of the switch module.
This tray contains the documentation, regulatory statements, and product information guide.
3. Remove the switch module from the box.
The protective foam ends will slide out with the switch module.
4. Remove the foam ends from the switch module.
5. Be sure that you have taken the necessary precautions for electrostatic sensitivity; then break the warning seal.
6. Slide the switch module out of the antistatic sleeve and inspect it carefully for any obvious defects or shipping
damage.
7. For complete instructions to install the converged network switch into the Blade Server Enclosure, refer to the
section on installing a switch module in the Blade Server Enclosure Hardware Owner's Manual.
NOTE
Be sure to remove the protective covers from the midplane connectors before installing the module into the
enclosure.
Dell M8428-k Getting Started Guide
MHWKY
3 of 160